Southbend 4601DD-2RR User Manual download pdf (Page 9)

OWNER’S MANUAL 1190820 REV 4 (10/14)

PAGE

OF 34

ULTIMATE RESTAURANT RANGES

2. Install eye-bolt (item “F”) to a frame member on the rear of the equipment. After checking carefully behind the frame

member for adequate clearance, drill a 1/4” (6 mm) hole through the frame member.

3. Thread hex nut (item “G”) and slide the washer (item “H”) onto the eye-bolt. Insert the eye-bolt through the 1/4”

(6 mm) drilled hole and secure with a washer (item “H”) and nylon lock nut (item “I”).

4. Using the spring-loaded snap hooks, attach the restraining device to the bracket and the eye-bolt.

5. Using the cable clamp (item “D”), adjust the restraining device extended length to prevent over-bending or kinking of

the appliance connector.

Figure 4

Be sure all controls are turned off prior to disconnecting. After reconnecting, be sure all controls are turned off and all

pilots are lit.

NOTICE

Adequate means must be provided to limit the movement of the appliance without depending on the connector and

the quick-disconnect device or its associated piping to limit the appliance movement.

The restraining means should be attached to a frame member on the back of the range.

INSTALLATION

Installation of Restraint

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 33 34

No comments

Southbend 4601DD-2RR User Manual Page 9