Southbend 4601DD-2RR User Manual download pdf (Page 6)

ULTIMATE RESTAURANT RANGES

OWNER’S MANUAL 1190820 REV 4 (10/14)

PAGE

OF 34

NOTICE

These installation procedures must be followed by qualied personnel or warranty will be void.

Local codes regarding installation vary greatly from one area to another. The National Fire Protection Association, Inc.

States in its NFPA 96 latest edition that local codes are the “authority having jurisdiction” when it comes to installation

requirements for equipment. Therefore, installations should comply with all local codes.

The installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code,

ANSI Z223.1, Natural Gas Installation Code, CAN/CGA-B149.1, or the Propane Installation Code CAN/CGA-B149.2,

as applicable, including:

1. The appliance and its individual shutoff valve must be disconnected from the gas supply piping system during any

pressure testing of that system at test pressures in excess of 1/2 psi (3.45 kPa).

2. The appliance must be isolated from the gas supply piping system by closing its individual manual shutoff valve

during any pressure testing of the gas supply piping system at test pressures equal to or less than 1/2 psi (3.45

kPa).

IMMEDIATELY INSPECT FOR SHIPPING DAMAGE

All containers should be examined for damage before and during unloading. The freight carrier has assumed

responsibility for its safe transit and delivery. If damaged equipment is received, either apparent or concealed, a claim

must be made with the delivering carrier.

Apparent damage or loss must be noted on the freight bill at the time of delivery. The freight bill must then be signed

by the carrier representative (Driver). If the bill is not signed, the carrier may refuse the claim. The carrier can supply

the necessary forms.

A request for inspection must be made to the carrier within 15 days if there is concealed damage or loss that is not

apparent until after the equipment is uncrated. The carrier should arrange an inspection. Be certain to hold all contents

plus all packing material.

1. Cut the banding straps and remove the corrugated cardboard surrounding the range. If legs were shipped in the same

container, set them aside for installation in later steps of this procedure. Do not remove any tags or labels attached

to the range until the range is installed and working properly.

2. Lift the ue riser and shelf (if applicable) off the range and set it aside for installation later in this procedure.

3. Unbolt the shipping hold-down brackets from the skid, then remove the brackets from the range. Replace the bolt back

on to the threaded holes in the range.

4. If the range is to be installed on legs, go to Step 2a.

If the range is to be installed on casters, go to Step 2b.

STEP 1: UNPACKING

INSTALLATION

NOTICE

EXHAUST FANS AND CANOPIES: It is recommended that the range be installed under a ventilation hood. Consult

local codes for proper installation of hoods. Proper ventilation is the owner’s responsibility. Any problem due to

improper ventilation will not be covered by warranty.

NOTICE

In the Commonwealth of Massachusetts all gas appliances vented by either mechanical systems or ventilation hoods

shall comply with 248 CMR interlocking requirements.

INSTALLATION

1 2 3 4 5 6 7 8 9 10 11 ... 33 34

Comments to this Manuals

No comments

Southbend 4601DD-2RR User Manual Page 6

Comments to this Manuals