Southbend 4601DD-2RR User Manual download pdf (Page 24)

ULTIMATE RESTAURANT RANGES

OWNER’S MANUAL 1190820 REV 4 (10/14)

PAGE

OF 34

Problem Look for -

Oven will not come on. – Oven pilot is out.

Oven pilot will not stay ignited – Pilot gas not adjusted properly.

– Bad thermopile.

– Bad thermopile connections at safety valve.

– Bad safety valve.

– Clogged orice.

– Dirty pilot

– Draft condition.

– Improper ventilation system.

– Air in gas line.

CAUTION

Proper and efcient operation of oven is dependent on correct installation and function of components. Always verify

that components are in place and functioning as intended.

TROUBLESHOOTING BASE OVEN

Consult the following table and the owchart that begins on the following page.

Figure 7

Troubleshooting Oven Pilot

TROUBLESHOOTING

Oven pilot does not work.

Does the pilot light?

Yes

Check that the oven pilot adjustment on the gas valve is open.

Continue to hold the button for 30 seconds. The pilot should remain

lit after the button is released. If it does not, wait five minutes and

try again.

If the pilot will not remain lit, do the following: Set a multimeter to

the thermopile connections on the safety valve to test the DC

millivolts of the thermopile. While holding the button, light the pilot

and messure the voltage produced by the thermopile. The voltage

should read abobe 450 millivolts.

If the pilot is not lit, attempt to light the pilot by raising the kick panel

slightly and rotating its top edge outward. Press and hold the button

on the oven safety valve and put a flame to the pilot.

If the pilot still will not light, do the following: Remove the oven

bottom. Loosen the pilot nut on the burner bracket. Remove the

pilot tube from the safety valve. Remove the pilot orifice from the

pilot or end of the tube and check for debris.

Re-install the pilot orifice and tubing.

Check whether the pilot flame is lit by looking through the hole in

the bottom of the oven. Leave the oven door open for five minutes

to allow gas fumes to clear.

If the voltage does not rise above 450 millivolts, then adjust or

clean the pilot assembly to chieve a larger flame. If the voltage

will not adjust properly, then replace the thermopile.

if you continue to have issues after replacing the thermpile, then

contact Southbend Technical Support for assistance at

919-762-7621000 option 2.

Does the pilot light?

Yes

If the voltage of the thermopile is oven 450 millivolts, then remove

the thermostat wires and test the pilot again. If the pilot continues

to fail, then replace the safely Value. If you continue to have

issues after replacing the safety valve, then contact Southbend

Technical Support for assistance at 919-762-1000 option 2.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 33 34

Comments to this Manuals

No comments

Southbend 4601DD-2RR User Manual Page 24

Comments to this Manuals