Southbend StratoSteam STRE-5D User Manual download pdf (Page 13)

STRATOSTEAM ELECTRIC COUNTERTOP STEAMER INSTALLATION

OWNER’S MANUAL 1189951 (10/08) PAGE 13 OF 56

STEP 2A: ATTACH LEGS

A set of four legs is packed with steamers ordered with legs.

A threaded hole is located at each corner. Each leg has a corresponding mating thread. The legs can be adjusted to

overcome a slightly uneven surface.

1. Raise the steamer sufficiently to allow the legs to be attached. For safety, “shore up” and support the steamer

with an adequate blocking arrangement strong enough to support the load.

2. Screw the legs into the holes (see

Figure 4). Note that the front legs are different than the rear legs.

3. Lower the steamer gently onto a level surface. Never drop or allow the steamer to fall.

4. Make sure that the steamer is level (both side-to-side and front-to-back). If necessary, adjust the height of each

leg by turning the foot-pad of the leg.

5. Go on to Installation Step 3.

Figure 4

Attach Legs

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 55 56

No comments

Southbend StratoSteam STRE-5D User Manual Page 13